The first method:

1. Blow on with a hair dryer for 20 minutes;

2. Recovery method with boiling water;

3. Use metal materials to dent. My car bumper is dented, how do I fix it?

The first is to blow it with a hair dryer for 20 minutes, one of the methods.

The second method is the boiling water recovery method. Boil a pot of hot

water and pour it into the depression of the car bumper continuously. After

about 5 minutes, you can push it out with your hands.

The third method is metal dents. First, use a high-viscosity glue stick to attach

to the glue gun and power it up, and then apply the melted glue to the film.

Second, stick the film on the dent position and press it with your hand.

Third, put on the dent puller, tighten the knob to fasten the film, and then slowly

pull up. Fourth, spray a few times with the glue remover, and use a scraper to shovel away the residual glue.